Table of Contents
Advertisement
MAX-CSE Specifications (Cont.)
Supported Audio Codecs:
Front Panel Components:
• ID pushbutton:
• Status LED:
• LCD Display:
• IR Receiver:
Rear Panel Connectors:
• COMPOSITE IN:
• 12VDC PWR:
• S-VIDEO IN:
• ETHERNET 10/100:
• AUDIO R/L:
• RS-232/422/485:
• MIC:
• IR/Serial:
MAX-CSE/MAX-CSD10 Operation/Reference Guide
• MPEG Audio Level 2 (MP2)
• MPEG Audio Level 3 (MP3)
Used to set the NetLinx ID (Device only) assignment and reset the unit to
factory defaults. Press and hold this button for at least 10 seconds to set
the unit back to its default settings.
Green LED provides an indication of both the system status and communi-
cation status with the target Master.
1 blink every 5 seconds indicates there is currently active communication
between the CSE and a target Master.
Provides system information such as the currently used IP Address.
Receives 38KHz AMX IR codes.
BNC connector (female) supports Composite Video Input (NTSC/PAL).
2-pin 3.5mm mini-Phoenix (male) captive-wire connector for power from
an optional 12 VDC-compliant power supply (overrides POE).
Mini-Din4 port for composite S-Video input.
RJ-45 port provides 10/100 Mbps network communication and POE. LEDs
show communication activity, connection status, speeds, and mode infor-
mation:
• SPD (speed) - Yellow LED lights On when the connection speed is 100
Mbps and turns Off when the speed is 10 Mbps.
• L/A (link/activity) - Green LED lights On when the Ethernet cables are
connected/terminated correctly, and then blinks when receiving Ethernet
data packets.
This port automatically negotiates the connection speed (10 Mbps or 100
Mbps), and whether to use half or full duplex mode.
• Two RCA connectors support line-level stereo input for analog stereo
signals.
9-pin (DB9) port supports RS-232/RS-422/RS-485 data output including:
300, 600, 1,200, 2,400, 4,800, 9,600, 19,200, 38,400, and 115,200 Baud
rates
• 8 or 9 Data bits
• 1 or 2 Stop bits
• Even, Odd, Mark, Space, and None parity settings
• CTS and RTS handshaking
• XON/XOFF handshaking
1/8" mini-stereo input jack.
2-pin 3.5mm mini-Phoenix (male) captive-wire connector provides
IR/Serial control output by generating IR with the use of an IR Emitter
(while in IR mode).
This port supports high-frequency carriers of up to 1.142 MHz and can
also generate IR with no carrier frequency.
MAX-CSE Video Encoder
3
Advertisement
Table of Contents
