Table of Contents
Advertisement
MAX-CSE Web Interface
Administration Page Features (Cont.)
Feature
• IP Settings
• User
Stream Status:
• Play/Stop
• Status
• Video Sync
• Refresh
• Mic Off
22
Description
This button launches the IP Settings page, which provides the user with the abil-
ity to assign the method of communication used by the target MAX unit, along
with its associated IP parameters.
This button launches the User page, which provides the user with the ability to
alter the current Username/Password information required to gain entry to the
UI pages and make modifications.
Located on the lower-left side of the browser window, this static frame allows a
user to not only Start and Stop an encoding stream, but also view whether the
MAX-CSE is detecting an A/V signal.
Since this frame is static, it appears on-screen no matter what page is currently
active. This frame can be very useful for a remote administrator when trying to
troubleshooting most streaming issues.
There are two buttons which reflect the condition of the outgoing media content:
• Play begins to sync-up the media signals and then stream them out from the
device.
- This play state is shown as active when both the Stop button is displayed
and the green
Streaming
message is displayed within the Status field.
- No changes can be made to both the communication parameters and
stream profiles while the unit is in this mode.
• Stop halts the outgoing media stream from the device.
- This stop state is shown as active when both the Play button is displayed
and the blue
Idle
message is displayed within the Status field.
- Changes can be made to both the communication parameters and stream
profiles while the unit is in this mode.
Indicates the status of the outgoing stream.
•
Streaming
indicates that the Play button has been activated and the process
of converting A/V content into an outgoing media stream has begun.
Streaming does not require that content be provided to the unit, it is only the
conversion process which has been initiated. This is why it is important to
make sure that the unit is also detecting an incoming A/V feed.
•
Idle
indicates that the Stop button has been activated and the stream process
has been halted.
Indicates whether the unit is detecting an incoming A/V signal through its rear
connectors.
•
SYNC
indicates that the incoming A/V signals have been detected and then
synchronized prior to being streamed out from the MAX-CSE.
•
LOS
(Loss Of Signal) indicates there is no incoming signal being detected by
the unit and therefore, the outgoing stream contains no data. Remember, a
stream can be initiated and maintained without there being any signal fed into
the unit. It is important to verify the status of the incoming signal.
This button causes the unit to re-verify the condition/state of both the stream
Status and Video Sync.
If you have already initiated a stream and get a
correct the problem and click the Refresh button to try and verify the condition
of the incoming A/V signal without needing to Stop the stream process.
Click to toggle the audio state of the incoming microphone signal between active
and muted.
MAX-CSE/MAX-CSD10 Operation/Reference Guide
LOS
message, you can try to
Advertisement
Table of Contents
