AMX MAX-CSD 10 Operation And Reference Manual page 12

MAX-CSD10 Video Decoder
The following table outlines the specifications for the MAX-CSD10 Video Decoder.
MAX-CSD10 (FG2178-72) Specifications
Dimensions (HWD):
Power Requirements:
Weight:
Enclosure:
Certifications:
Video Outputs:
Audio Outputs:
Supported Resolutions:
Supported Video Codecs:
Supported Audio Codecs:
Front Panel Components:
• ID Pushbutton:
• Status LED:
• LCD Display:
• IR Receiver:
Rear Panel Connectors:
• S-VIDEO OUT:
• ETHERNET 10/100:
• AUDIO R/L:
• 12VDC PWR:
• COMPOSITE OUT:
• IR/Serial:
6
1.58" x 5.54" x 6.95" (4.01 cm x 14.07 cm x 17.65 cm)
• 500mA @ 12VDC (6W)
• Power Over Ethernet ( ) is available.
POE
• Optional 12VDC power input overrides
• Power requirements are usage dependant.
• This product is intended to be supplied by a Listed external power supply
rated from 10 to 18 VDC, minimum 500 mA or equivalent.
2.02 lbs (0.92 kg)
Metal with black matte finish
FCC Part 15 Class B, CE, and UL listed
Composite Video (via BNC)
S-Video (via standard female S-Video connector)
Analog Stereo (RCA connectors - Red/White)
• NTSC (480i)
• PAL (576i)
• MPEG2 (2 Mbps - 6 Mbps)
• MPEG4 (500Kbps - 3 Mbps)
• MPEG Audio Level 2 (MP2)
• MPEG Audio Level 3 (MP3)
• AAC
Used to both set the NetLinx ID (Device only) assignment and reset the unit
back to its factory defaults.
Green LED blinks to indicate both the system and communication status with
the target Master.
Provides system information such as the currently used IP Address.
• Receives 38KHz AMX IR codes.
Mini-Din4 port for composite S-Video output.
Single RJ-45 port provides 10/100 Mbps network communication and
LEDs show communication activity, connections, speeds, and mode informa-
tion.
Two RCA connectors (Red and White) support line-level stereo output for ana-
log stereo signals.
Single 2-pin 3.5mm mini-Phoenix (male) captive-wire connector from an
optional 12 VDC power supply (overrides
Composite Video Output (NTSC or PAL) via a female BNC connector.
Single 2-pin 3.5mm mini-Phoenix (male) captive-wire connector is used for IR/
Serial control output by generating IR with the use of an IR emitter (while in IR
mode).
This port can support high-frequency carriers of up to 1.142 MHz and can also
generate IR with no carrier frequency.
MAX-CSE/MAX-CSD10 Operation/Reference Guide
when used.
POE
POE
).
POE
.