Wiring The Max-Cse Connectors And Cables - AMX MAX-CSD 10 Operation And Reference Manual

Amx corporation max video encoder & video decoder operation/reference guide
Table of Contents

Advertisement

MAX-CSE and MAX-CSD10 Installation

Wiring the MAX-CSE connectors and cables

The rear connectors on the MAX-CSE (FIG. 5) are used to input external multimedia signals and then
stream them to the network/web. This stream can be displayed through either a MAX-CSD10 Decoder,
VG-Series Modero Touch Panel or through a third-party player such as VLC
12 VDC power
supply
FIG. 5
MAX-CSE connector wiring diagram
The rear-panel wiring connections are described below (from left to right):
12
COMPOSITE IN (BNC)
S-VIDEO IN (MiniDin4)
Outbound Audio/Video/Data (RJ-45)
Ethernet - Data (RJ-45)
RS232/422/485
Right Audio Channel IN
Left Audio Channel IN
Microphone IN
• COMPOSITE IN:
Uses a BNC connector to feed a Composite video signal in from an
outside video source and then out to an external streaming media
display or device via the Ethernet port.
The BNC connector can be modified to receive signals from an RCA
connector by using the included BNC to RCA Adapter (41-1074).
This signal can also be fed from a DB15 connector by using an
optional NXA-RGBCBL (15-pin to 5X BNC) RGB Breakout cable
(FG2250-80).
Note: Although the MAX-CSE can accept either a Composite or
S-Video input signal type. If both signal types are detected, the unit (in
its default state) will use the Composite signal. This selection can be
later changed by the user via the A/V Setup UI page.
• S-VIDEO IN:
Uses a female S-Video connector to feed a video signal in from an
external video source and then out to an external streaming media
display or device via the rear Ethernet port.
Note: Although the MAX-CSE can accept either a Composite or
S-Video input signal type. If both signal types are detected, the unit (in
its default state) will use the Composite signal. This selection can be
later changed by the user via the A/V Setup UI page.
• PWR
2-pin 3.5 mm mini-Phoenix connector connects to a direct
12 VDC-compatible power supply.
or
R
E
IR/Serial
A
I/O
R
MAX-CSE/MAX-CSD10 Operation/Reference Guide
®
.
F
R
O
N
T

Advertisement

Table of Contents
loading

This manual is also suitable for:

Max-cseMax-csd10Max-cse10

Table of Contents