Configuring The Max-Cse Audio/Video Inputs - AMX MAX-CSD 10 Operation And Reference Manual

12. Enter a numeric value into the Target Port field. This field corresponds to the port on the destination
device to which the outgoing video (audio/video) stream is being directed.
13. If using RTP as a Transport Protocol, enter a value into the Target Audio Port field. This field
corresponds to the port on the destination device where the audio only portion of the stream is being
directed to. This value cannot match the value entered into the Target Port field above. If using
UDP as a Transport Protocol, this field becomes greyed-out and unused since the both the audio and
video content is being combined into a single stream.
14. Click the Apply button to save the encoding profiles to the MAX-CSE.
If using RTP, both the Target Port and Target Audio Port must be different and
should use even numbers.

Configuring the MAX-CSE audio/video inputs

1. Complete the MAX-CSE connection and wiring procedures outlined within the Wiring the MAX-
CSE connectors and cables section on page 12.
2. Access the A/V Setup page (FIG. 43) by clicking the Audio/Video button in the Navigation Bar.
This page provides the user with the ability to select the source of the incoming video signal (from
either the rear Composite or S-Video port), the format of the incoming video (NTSC/PAL), and the
gain given to the incoming audio signal.
FIG. 43 A/V Setup page
3. From within the Video section of this page, check off the appropriate Video In and Video Port radio
boxes which correspond to both the type of video signal being used and its associated format.
MAX-CSE/MAX-CSD10 Operation/Reference Guide
It is recommended that this value not currently be used by another port on the target device.
It is recommended that the following ports also not be used: 21, 22, 23, 80, 443, and 1319.
For the purposes of these procedures, we've chosen to use 5000 as the video Target Port.
For the purposes of these procedures, we are not required to enter a Target Audio Port value
because the A/V content is not begin streamed separately.
For the purpose of these procedures, we've chosen to feed an NTSC signal into the rear
Composite video connector. As a result, a user should "check-off"/select both the Composite
and NTSC radio boxes.
Displaying Stream Content
67