Table of Contents
Advertisement
best progress when sawing, use light pressure on
the saw blade.
6. When sawing along a marked line use the
marking on the splitting guard as a guide.
7 . For exact cutting, clamp a timber batten on to
the material as an aid or use the parallel guide.
8. For mitres/bevels, set the base plate in the
required position.
9. Set the base plate to its rearmost position for
cutting close to an edge.
MAINTENANCE
Warning:
disconnected from the mains power
supply before attempting any maintenance.
1) Keep the jigsaw ventilation slots clean and free
from obstructions. If available, blow compressed
air into the vents to clear any internal dust (safety
goggles must be worn when undertaking this
process).
2) Keep the outer case of the jigsaw clean and
free from grease. Do not wash with water or use
solvents or abrasive. Use only mild soap and
damp cloth to clean the tool. Never let any liquid
get inside the tool. Never immerse any part of the
tool into a liquid.
3) Your jigsaw requires no additional lubrication.
There are no user serviceable parts in your power
tool.
4) Always store your power tool in a dry place.
5) If you see some sparks flashing in the ventilation
slots, this is normal and will not damage your
power tool.
6) If the supply cord is damaged, it must be
replaced by a special cord or assembly available
from the manufacturer or its service agent.
TROUBLESHOOTING
1 If your jigsaw will not operate, check the fuse
and the power at the mains plug.
2 If the jigsaw is not cutting properly check the
blade and support roller, replace blade if worn.
Also check the cutting angle, the blade must be at
exactly 90° to the base plate for normal use.
3There are no user serviceable parts in the jigsaw.
If a fault can not be found return the saw to an
authorised dealer for repair.
800W JIGSAW WITH LASER
SF800XPL SJ800XPL-M-060525.indd 15
Ensure
the
jigsaw
is
SF800XPL
2006-5-26 18:34:48
Advertisement
Table of Contents
