Table of Contents
Advertisement
Fig 15a
Fig 15b
Fig 16a
Fig 16b
SF800XPL SJ800XPL-M-060525.indd 14
13. Using the laser generator
1. The laser generator is for the purpose of
precision cutting. Make sure the batteries are
fitted in the laser generator before carrying out
precision cutting. To fit the batteries, remove the
battery storage cover as shown, insert the 2 x
1.5V battery (supplied), then replace cover. (See
fig15a and 15b)
Note: Ensure the correct battery polarity before
fitting the batteries.
2. To use the laser generator, simply press down
the on/off switch, (See fig16a), the laser generator
then projects a visible red line on the workpiece
surface, make your mitre cut along the red line.
(See fig16a and 16b)
Note:
- The saw dust may block the laser beam, clean
the laser generator periodically.
- Switch off the laser when you stop the machine.
The laser does not off automatically.
Caution
Switch off the laser when stop the machine, take
out batteries if you do not need to use the laser
for a long time.
Never stare directly into the laser beam and never
point the beam at anybody.
WORKING HINTS FOR YOUR
PRODUCT
1. Here is some advice on the pendulum action
control: the saw blade is only pressed against the
material on the return stroke/working stroke. It
is moved away from the material on the forward
stroke. The result is better removal of chips, less
friction and therefore a higher output.
2. To avoid the jigsaw springing up and down
when sawing sheets, support the sheet on
timbers. When sawing metal, apply a coolant oil
along the cutting line.
3. Adjust the speed and the pendulum action
settings to suit the material to be sawn.We always
recommend that you carry out a test cut first.
4. To use the jigsaw put the front end of the base
plate on the material and turn the machine on.
Press the machine from above on to the material
and guide the jigsaw along the cutting line.
5. Do not use too much pressure to achieve the
2006-5-26 18:34:48
Advertisement
Table of Contents
