Titan SF800XPL Safety And Operating Manual page 11

3. Using the parallel guide (See fig5)
The parallel guide allows you to make an accurate
parallel cuts using the metric scale. Release the
quick set mechanism on the parallel guide. Put
it into the required position and lock quick set
mechanism again. Slide the parallel guide in from
the appropriate side (left or right) accordingly.
Make sure that the guide surface of the parallel
guide points downwards.
4. Assemble Dust extraction adaptor
Note: only use the equipment with a compatible
vacuum chip extractor to attach, inset the extractor
into the back of the jigsaw, rotate the vacuum
hose on to the extraction nozzle and test whether
it is securely held in place. (See fig6)
5. Operating the trigger switch (See fig7)
To operate the Pendulum Jigsaw, depress the
trigger switch. If you wish to use the Pendulum
Jigsaw continuously, the trigger lock button can
be pushed in after the trigger switch has been
depressed. To release the lock button push in the
trigger switch again.
6. Pendulum action switch adjustment (See
fig8)
The adjustable 4-stage pendulum action makes
it possible to adjust the blade penetration on the
upward stroke for the various working materials.
Optimal cutting performance is thereby achieved.
The saw blade is lifted from the workpiece on the
downward stroke. This results in improved chip
ejection while substantially reducing frictional
heat and increasing the life expectancy of the saw
blade.
The pendulum action can be adjusted to one
of four stages with pendulum action knob. The
setting can be changed while the machine is
operating:
Stage 0: Pendulum action off
Stage 1: Low pendulum action
Stage 2: Moderate pendulum action
Stage 3: High pendulum action
7. The following rules should be observed
-The pendulum action should be off when
working with thin materials such as sheet metal.
- Shut off pendulum action when using rasps or
knifes.
800W JIGSAW WITH LASER
SF800XPL SJ800XPL-M-060525.indd 11
Fig 5
Fig 6
Fig 7
Fig 8
SF800XPL
2006-5-26 18:34:45