Weighing To A Certain Target Weight /Target Quantity And Tolerance Control; Tolerance Control In Weighing Mode - KERN CFS Operating Manual

11 Weighing to a certain target weight /target quantity and toler-
ance control
The balance allows weighing of goods to a certain target weight (net weight) or tar-
get piece number within defined tolerances. With this function one can also check if
the weighing good is within a defined tolerance range. Tolerance control is possible
in weighing or target mode.
Reaching the target value is indicated by an acoustic (if activated in menu) and an
optic signal (tolerance mark

11.1 Tolerance control in weighing mode

Press , the active tolerance weighing mode is
indicated.
If necessary, with
mode" select [
Press , the currently set upper limit value is dis-
played.
Using numeric keyboard enter desired value or
delete using .
Press , the currently set lower limit value is dis-
played.
Using numeric keyboard enter desired value or
delete using .
Press , tolerance control is started. The
Place the weighing goods and with help of the tolerance mark
weight of the weighed goods is under, within or over the specified tolerance.
Display of tolerance mark
CFS/CCS-BA-e-1013
).
Operation
"Tolerance control weighing
]
, if weighing goods under the specified tolerance:
Display
symbol over appears.
check if the net
29