Program 110 - Plu Auto Tare Programming - Sam4s ER-390M Operator's And Programming Manual

Program 110 - PLU Auto Tare Programming

70 • P-Mode Programming
1. Turn the control lock to the P position.
2. To begin the program, enter 1 1 0, press the SBTL key.
1 1 0
3. Select the PLU or PLUs you wish to program in one of the following ways:
•
Press a PLU key on the keyboard, or
PLU
•
If sequential PLUs are to receive the same status, press the first PLU key and then
press the last PLU key, or
PLU PLU
•
Enter the number of the PLU and press the PLU key, or
•
Enter the number of the first PLU in a range of PLUs that are to receive the same
setting; press the PLU key. Enter the last number in the range; press the PLU key.
4. Enter a value (1-4) to indicate the number of the preprogrammed tare weight you want to
automatically subtract when the PLU is used for scale entry (using an optional scale), and
then press the X/TIME key. Enter 0 to disable automatic tare subtraction. NOTE: PLU
must be set for auto-scale entry.
X/TIME
5. To program additional PLUs, repeat from step 3, or press the CASH key to finalize the
program.
CASH
SBTL
PLU
PLU
ER 390M Electronic Cash Register v1.2
PLU