Display Panel - HP ProOne 400 G1 Maintenance & Service Manual

5.
If necessary, press
6.
Edit the fields listed. If the feature byte has data or is not editable, then it was not cleared and
cannot be edited.
System ID Setup Page
Setup Field Name
Product Name
Serial Number
SKU Number
Asset Tag
Feature Byte
Build ID

Display panel

Description
Display panel kit (includes touch controller board and backlight cable)
NOTE:
You MUST remove and replace all parts that come in the kit.
NOTE: Do not reuse any old parts. Return all old parts to HP for warranty processing.
Display panels are available from two different manufacturers — LE and BOE.
Display panels require a backlight cable specific to the manufacturer. Make sure you use the backlight
cable packaged with the display panel.
The display panel kit includes the touch controller board. The touch controller board is located on the
left side of the computer (viewed from behind) under the main rear cover above the converter board. It
is secured with two Torx screws and has two connectors.
IMPORTANT:
replace the touch sensor board when replacing a touch display panel. Failure to use the board
supplied in the kit could cause the touch module to function incorrectly.
The display panel is secured to the base pan with four Torx screws.
82 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Ctrl+A to initiate edit mode.
Enter the Model name/number or marketing name.
Enter the Serial Number of Unit.
Enter the SKU or Product Number including Localization Code.
Enter the 18-byte identifier assigned to the computer.
Enter the Feature Byte string. The feature byte string is case sensitive.
The label includes spaces after every four characters. You can enter or ignore
these spaces – their only purpose is to help with data entry. There is a
character limitation of 40 bytes per line. When you reach this limit, go to the
next line to continue data entry. BIOS ignores the spaces and lines.
If you make an error during data entry, the data will not validate, and the
computer asks you to correct your data input.
The Build ID of the unit.
Touch sensor boards are spared with the touch panel spare part kit. Be sure to
Comment Label
Flexbuild
Support
Support
Support
Flexbuild
Flexbuild
Spare part number
763203-001