Installing A 2.5-Inch Solid State Drive (Ssd), Self-Encrypting Drive (Sed), Or Solid State Hybrid Drive (Sshd) - HP ProOne 400 G1 Maintenance & Service Manual

Installing a 2.5-inch solid state drive (SSD), self-encrypting drive (SED), or solid state hybrid
drive (SSHD)
1. Insert the 2.5-inch solid state drive (SSD), self-encrypting drive (SED), or solid state hybrid drive
(SSHD) into the 2.5-inch drive adapter (1). Be sure that the connector is at the opening of the
adapter.
2. Fasten the four screws (2) to secure the 2.5-inch solid state drive (SSD), self-encrypting drive (SED),
or solid state hybrid drive (SSHD) in the 2.5-inch drive adapter.
3.
Slide the 2.5-inch drive adapter into the hard drive cage (1).
4.
Screw the four mounting screws with grommets through the sides of the hard drive cage into the
2.5-inch drive adapter (2). Be sure to keep the blue rubber grommets behind each screw.
5. With the 2.5-inch drive connector facing toward the center of the chassis, place the drive cage
into the chassis and slide it toward the center until it snaps into place (1).
44 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis