Fan - HP ProOne 400 G1 Maintenance & Service Manual

Fan

Description
Fan
The fan is located near the middle of the computer and is secured with three Torx screws. You do not
have to remove the heat sink to remove the fan.
To remove the fan assembly:
1. Prepare the computer for disassembly (see
2. Remove the rear cover (see
3. Remove the VESA panel (see
4. Remove the system board shield (see
5. Disconnect the fan cable from the system board connector labeled CHFAN (1).
NOTE:
cable straight out of the connector at a vertical (90°) angle.
6. Remove the three Torx screws that secure the fan to the computer (2).
70 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Rear cover on page
VESA panel on page
To avoid damaging the connector when disconnecting the cable, be sure to pull the
Preparing to disassemble the computer on page
34).
61).
System board shield on page
Spare part number
763214-001
62).
31).