HP ProOne 400 G1 Maintenance & Service Manual page 96

9. Disconnect the display cable (1) and the ZIF connector cables (2) from the touch sensor board.
NOTE:
through the main system bracket (3). You will have to reroute the cables through these routing
paths when reinstalling. See the end of this section for a detailed image of how the cables route
through the system bracket.
Pull the cable out from under the converter board.
10.
Lift the display panel from the frame.
11.
Remove the brackets from the display by removing the two Torx screws from each side, and then
lifting the brackets from the display.
NOTE:
sides.
NOTE:
12.
Be sure to correctly position the jumpers on the converter board for the installed display panel.
86 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
When removing and installing the display panel, note the locations that the cables route
The image below shows screws on only one side. Screw locations are similar on both
You must remove and reuse the display brackets when you replace the panel.