Heat Sink - HP ProOne 400 G1 Maintenance & Service Manual

Heat sink

Description
Heat sink
The heat sink is located near the middle of the computer and is secured with four captive Torx screws
and one non-captive Torx screw. You do not have to remove the heat sink to remove the fan.
To remove the heat sink:
1.
Prepare the computer for disassembly (see
2.
Remove the rear cover (see
3.
Remove the VESA panel (see
4.
Remove the system board shield (see
5. Remove the non-captive Torx screw from the end of the heat sink (1).
72 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Preparing to disassemble the computer on page
Rear cover on page 34).
VESA panel on page
System board shield on page
61).
62).
Spare part number
763213-001
31).