Warning Labels - SawStop PCS175 Owner's Manual

Warning Labels

Warning labels are mounted on the right and back sides of the saw, on the
table insert, on the switch box, and on the motor cover. Some of the warnings
on those labels may be additional to the warnings listed above. Be sure to
read the warning labels before using the saw. Copies of the English text of the
warning labels are reproduced below:
SawStop
reduce the potential for a serious injury
in the event of accidental contact with the
This saw operates differently than
ordinary table saws. Each operator
must read and understand the
10 SawStop 10" Professional Cabinet Saw
WARNING
!
To avoid loss of SawStop
protection during coast down,
do not turn off Main Power until
blade has stopped spinning.
WARNING
!
Do not operate with door open.
The blade can retract and cause
a severe injury if you touch it inside
the cabinet. Also, moving parts can
cut, pinch or crush.
WARNING
!
Moving gears and parts
can pinch, cut or crush.
Do not operate with
door open.
Thank you for
purchasing this
®
SawStop table saw.
This saw is equipped with the
®
safety system, designed to
saw blade.
Owner's Manual before
operating this saw.
!
WARNING
For your own safety,
read the instruction manual
before operating this saw.
1. Wear eye protection.
2. Use the blade guard and spreader
for every operation for which it can
be used, including all through
sawing.
3. Keep hands out of the line of the
saw blade.
4. Use a push-stick when required.
5. Know how to reduce the risk
of kickback.
6. Do not perform any operation
freehand.
7. Never reach around or over the
saw blade.
8. Never try to test fire the brake
system.
9. Never adjust the position of the
brake cartridge while the blade is
spinning.
10. Do not try to disable the brake
system.
11. Unplug the saw before changing
the blade, changing the brake
cartridge or servicing.
12. Do not connect the motor directly
to a power supply.
13. Use the bypass switch only when
necessary.
14. Do not expose to rain or use in
damp locations.
15. Do not put your hands inside or
underneath the cabinet while the
blade is spinning.
16. Do not unplug or disconnect the
saw from electrical power before
the blade has stopped spinning.
17. If connected to a circuit protected
by fuses, use time delay fuse
marked D.
WARNING
!
Moving belts and parts
can pinch, cut or crush.
Do not operate with
door open.