AddPac VoiceFinder AP2120 User Manual page 75

VoiceFinder AP2120 VoIP Gateway User's Guide Version 1.00
[Example] Additional Commands for PAP Configuration (Server)
If the Gateway functions as a server, it means AP2120 Gateway functions as
the PPP authentication server.
Router(config)# user ADDPAC password ADDPACRouter1 normal
Registers the user name (addpac) and the password (Router1) with the
normal priority in the server.
Router (config)#interface ethernet 0.0
interface configuration mode.
Router(config-ether0.0)# encapsulation ppp
Router(config-ether0.0)# ppp authentication pap
authentication mode as PAP for the ethernet0.0 interface.
Router(config-ether0.0)# ip address 132.12.1.1 255.255.255.0
☞ Sets the IP address as "130.1.1.1" and the subnet mask as "24Bit."
Router(config-ether0.0)#
132.12.1.2
IP from this Gateway, this command enables the Gateway to provide
default address (130.1.1.2)to the other Router. (* If an IP address
has been set already in the other Router, the operator does not need
to use this command.)
Router(config-ether0.0)# ppp timeout 100
negotiation timeout value as 100 seconds.
Router(config-ether0.0)# end
menu.
Router # debug ppp packet
Router #
Router # debug ppp packet
AddPac Technology Co., Ltd.
☞ When the other Router receives the serial interface
Ether0.0 LCP: TIMEOUT
Ether0.0 LCP: O CONFREQ id=1
Ether0.0 BCP: TIMEOUT
Ether0.0 BCP: O CONFREQ id=1
Ether0.0 LCP: TIMEOUT
Ether0.0 LCP: O CONFREQ id=1
Ether0.0 BCP: TIMEOUT
Ether0.0 BCP: O CONFREQ id=1
ppp peer default-ip
☞ Sets PPP connection
☞ Exists from the configuration
☞ Decodes PPP Packet.
☞ Stops PPP packet debugging.
☞ Enters into the
☞ Sets the PPP mode.
☞ Sets the PPP
address
75
- -
☞