AddPac VoiceFinder AP2120 User Manual page 304

VoiceFinder AP2120 VoIP Gateway User's Guide Version 1.00
t303 value
tras value
tttl value
tidt value
treg value
5.7.5.20.2. Default Value
See the above.
5.7.5.20.3. Command Mode
Voice-Service Configuration Mode
5.7.5.20.4. Usage Guideline
This command is to partially set the global voice-service for the VoIP service.
A proper value has been set as the default value of the timeout.
recommended to use the default value in most of cases.
5.7.5.20.5. Example
In the following example, the timeout value of the RAS message has been set
three seconds.
voice service voip
timeout tras 3
AddPac Technology Co., Ltd.
Timeout value from
transmission till initial message reception.
range from 5 to 60 and the default value is 8. T303
value is expressed in seconds.
Timeout value from RAS message transmission till
reply message reception. Values range from 2 to
30, and the default value is 6.
expressed in seconds.
RAS time-to-live timeout value. Values range from
10 to 600, and the default value is 60. Values are
expressed in seconds.
the gatekeeper.
Inter-digit timeout value to enter digits into the
analog voice port. Values range from 1 to 600,
and the default value is 10. Tidt value is expressed
in seconds.
Timeout value for re-registration attempt upon
registration failure in the gatekeeper.
range from 10 to 600 and the default value is 30.
Treg value is expressed in seconds.
Q.931 Setup message
Values
Tras value is
This value is updated by
Values
304
-
It is
-