Auto Stay Arming Feature - Honeywell L5200 Series User Manual

SECURING THE PREMISES
Arming the System
Armed Stay
Disarm
10:18 AM June 8, 2010
If an invalid User Code is entered or if a valid user code has not been entered within 10 seconds, the system
will return to the "home" screen and it will not be armed.

Auto Stay Arming Feature

If this feature is enabled by installer, the LYNX Touch, when armed AWAY from the control's keypad or a Wireless Keypad,
automatically switches to the STAY mode if the Exit Time expires and no exit has been made. Exit must be made through
an Entry/Exit Zone (door). If exit is made through a Garage Door, the system will automatically switch to the STAY mode
when the Exit Time expires.
NOTE: If the exit route entry/exit sensor is in a check condition or has been bypassed it will result in a loss of interior protection because the
alarm system will arm STAY in this case. Consult with your installer for servicing of the entry exit zones or to turn off this feature if a
check condition on entry exit zones occurs.
Arming in Night Stay Mode
Use this mode when you are staying home, but require increased security. The mode Arms same as STAY mode,
but also arms preselected interior sensors (programmed by your installer), while other interior sensors are left
disarmed. This mode can be armed when you are staying home but expect someone to use the entrance door
later. However, persons entering later can enter through an entry/exit door but they must disarm the system
and must not violate any of the programmed interior zones to avoid sounding an alarm. Close all protected
perimeter windows and doors before arming. The green Ready indicator on the control should be lit if the
system is ready to be armed. When armed in Night STAY mode, the system will sound an alarm if a protected
zone is faulted, but you may otherwise move freely throughout the premises. Late arrivals can enter through
the designated entrance door without causing an alarm, but they must disarm the system within the entry
delay period or an alarm will occur. If Quick Arm was programmed by the installer, you do not need to enter the
security code to arm the system. The security code must always be used to disarm the system, however.
When NIGHT-STAY mode is on, the selected interior zones are armed and cause an alarm if anyone
enters those areas (e.g., waking in the middle of the night). To avoid sounding an alarm, you must
disarm the system before any activity takes place in those interior zones.
The Guest Code and Installer Code cannot disarm the system unless it was used to arm the
system. In addition, if the system is armed by pressing via Quick-Arming, neither the Guest Code
nor Installer Code can disarm the system.
Ready To Arm
Arm Away Arm Stay
Delay
10:18 AM June 8, 2010
4.
System
Zones
Message Phone
More
5200-100-017-V0
1.
Zones System
Message Phone
More
5200-100-014-V0
At the end of the exit delay the system announces
"Armed Stay" and displays the "Armed Stay" screen.
Select the Arm Stay icon, the system beeps once and
displays a keypad.
– 18 –