Honeywell L5200 Series User Manual page 48

USER FUNCTIONS
Automation
Ready To Arm
123!@#
Q W E R T
A S D F G
Z X C V
Clear
abc...
Ready To Arm
Name
Type
Disabled
Ready To Arm
Name
Type
Trigger Output
Start Zone Type
Not Used
Start System Operation Stop System Operation
Not Used
Y U I O P
H J K L
B N M
Done
5200-100-058-V0
01
Save
5200-100-060-V0
01
Action
None
Stop Zone Type
Not Used
Save
Not Used
5200-100-062-V0
4. Select the "Name" key and then enter up to 13 characters of
text on the displayed keyboard to assign a name to the Rule.
Note: Select the "ABC..." key to switch the keyboard between
upper/lower case or the "123!@#" key to switch to
numbers.
5 Once you are finished, select "Done". The system returns to
the Rules screen.
6. Select the "Type" button. Dependent upon the features
programmed in your control, the system toggles between the
following Types:
Disabled
Trigger Output
Scene (displayed when Z-Wave has been enabled)
To Ph. 1 (Message to Phone 1)
To Ph. 2 (Message to Phone 2)
To Ph. 1 & 2 (Message to Phone 1 & 2)
Email 1
The system displays several new programming fields,
dependent upon the Type that is selected.
If Scene was selected, refer to the Home Automation Guide
P/N 800-16091 for information.
7. Select "Action". Dependent
previously, the system scrolls between several options:
None
Permanent On
On for 2 sec
Pulsing
Send
Run Scene*
* If Scene was selected in step 6 refer to the Home Automation Guide
PN 800-16091 for information.
8. Select "Start Zone Type". Use the "" "" buttons to scroll to
second and third page of zone type options. The system
displays the following options (dependent upon the Type that
was selected).
Not Used
Entry Exit 2
Interior Follower
24 Hour Silent
Silent Burglary
Interior With Delay
Carbon Monoxide
No Response
Arm Away
Monitor
Resident Response
General Response
Garage Monitor
– 48 –
upon the Type
Entry Exit 1
Perimeter
Day / Night
24 Hour Audible
24 Hour Auxiliary
Fire No Verification
Trouble
Arm Stay
Disarm
Resident Monitor
General Monitor
Garage Door
selected