When An Alarm Occurs - Honeywell L5200 Series User Manual

When an Alarm Occurs

When an alarm has occurred, the touch screen displays the zone number(s) that caused the alarm and the type
of alarm (e.g., "Fire Alarm"). These messages remain displayed until cleared by a user. To clear the display,
note the zone number that is displayed and enter an Off sequence. If the fault cannot be corrected, notify your
alarm company.
Disarming the System and Silencing Alarms
Alarm
Alarm 2 Front
Door
Enter Code:
Cancel
Alarm Cancel
Alarm 2 Front
Door
Disarm
4:43 PM August 11, 2011
1 2 3
4 5 6
7 8 9
Clear 0
5200-100-088-V0
System
Zones
Message Phone
More
5200-100-089-V0
1. Enter a valid Code. The system beeps once and announces
"Disarmed Ready to Arm".
Note: If a valid user code is not entered before the programmed
entry delay occurs, the system remains in alarm mode.
2. "Alarm Cancel" is displayed in a red band along with the zone
that caused the alarm. Select the "Disarm" icon and enter a
second Off sequence to clear the alarm. The system beeps
once, returns to the Security Screen and announces
"Disarmed Ready to Arm".
– 27 –
SECURING THE PREMISES
Disarming the System