Bypassing Protection Zones - Honeywell L5200 Series User Manual

SECURING THE PREMISES

Bypassing Protection Zones

Bypassing Individual Zones
The Bypass feature can be used when you want to intentionally arm your system with one or more zones
unprotected. Bypassed zones are unprotected and will not cause an alarm when violated while your system is
armed. All bypasses are removed when an Off sequence is performed. The system will not allow
Panic, Fire or CO zones to be bypassed.
Bypassing Zones
Not Ready To Arm - Fault
Fault 2
Front Door
Delay
10:18 AM June 8, 2010
Not Ready To Arm - Fault
2. Front
Door
FAULT
Bypass All Clear
Faulted Bypasses
Not Ready to Arm - Fault
Bypass Selected Zones
Enter Code:
Cancel
Zones System
Message Phone
More
5200-100-026-V0
Select
Bypass
Fault
5200-027-027-V0
1 2 3
4 6
5
7 9
8
Clear
0
5200-100-083-V0
1. With the system in the disarmed state, select the "Zones"
icon. The system displays the Zones/Bypass screen.
2. Select the zone(s) that you wish to bypass and then select
"Bypass" OR if programmed, the "Bypass All Faulted" button
allows you to bypass all faulted zones (excluding Panic, Fire
or CO zones). The system displays a keypad.
3. Enter a valid Code. The system returns to the Bypass screen
and the zone(s) that are bypassed will be displayed.
4. Select the  icon to return to the Security Screen.
5. Arm the system normally. See Arming the System section for
the procedure.
– 28 –