Table of Contents
Advertisement
Use
Timeouts
Hibernate Timeout
Disabled
1 hour
2 hours
3 hours
6 hours
1 day
2 days
3 days
1 week
2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Print Timeout
Disabled
1–255 sec
User's Guide
To
Set the amount of time the printer waits after a job is printed
before it enters Hibernate mode.
Notes:
•
Disabled is the factory default setting in all countries
except European Union countries and Switzerland.
•
3 days is the factory default setting for all European Union
countries and Switzerland.
•
The setting is also disabled if the printer detects an active
Ethernet connection, regardless of country. However, to
enable the setting even with an active Ethernet
connection, click Settings >General Settings >Hibernate
Timeout on Connection >Hibernate.
To wake the printer from Hibernate mode, try one of the
following:
•
Press the Sleep button for less than three seconds if
Press Sleep Button is set to Hibernate.
•
Press and hold the Sleep button for more than three
seconds if Press and Hold Sleep Button is set to
Hibernate.
•
Turn off the printer, and then turn it back on.
Set the printer to Hibernate mode even if there is an active
Ethernet connection.
Note: Do Not Hibernate is the factory default setting.
Set the amount of time in seconds the printer waits to receive
an end-of-job message before canceling the remainder of the
print job.
Notes:
•
"90 sec" is the factory default setting.
•
When the timer expires, any partially printed page still in
the printer is printed, and then the printer checks to see if
any new print jobs are waiting.
•
Print Timeout is available only when using PCL emulation.
This setting has no effect on PostScript emulation print
jobs.
- 90 -
Advertisement
Table of Contents
Need help?
Do you have a question about the ineo 3300P and is the answer not in the manual?
Questions and answers