Adjusting Sleep Mode; Setting Hibernate Timeout - Develop ineo 3300P User Manual

Adjusting Sleep mode

To save energy, decrease the number of minutes the printer waits before it enters Sleep Mode.
Available settings range from 1 to 120 minutes. The factory default setting is 30 minutes.
Using the Embedded Web Server
1. Open a Web browser, and then type the printer IP address in the address field.
Notes:
- Print a network setup page or menu settings page, and then locate the IP address in the TCP/IP
section.
- If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2. Click Settings >General Settings >Timeouts.
3. In the Sleep Mode field, enter the number of minutes you want the printer to wait before it enters
Sleep Mode.
4. Click Submit.
Using the printer settings on the computer (Windows only)
• Access the Setup menu using the Local Printer Settings Utility.

Setting Hibernate Timeout

Hibernate Timeout lets you set the amount of time the printer waits after a print job is processed before it
goes into a reduced power state.
Using the Embedded Web Server
1. Open a Web browser, and then type the printer IP address in the address field.
Notes:
- Print a network setup page or menu settings page, and then locate the IP address in the TCP/IP
section. The IP address appears as four sets of numbers separated by periods, such as
123.123.123.123.
- If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2. Click Settings >General Settings >Timeouts.
3. From the Hibernate Timeout menu, select the number of hours, days, weeks, or months you want for
the printer to wait before it goes into a reduced power state.
4. Click Submit.
Using the printer settings on the computer
Depending on your operating system, access the Hibernate Timeout menu using the Local Printer
Settings Utility or Print Settings.
User's Guide
- 105 -