Using The Remote Control; Auxiliary Mode; Loading Batteries - Sharp AY-AP9KR Operation Manual

USING THE REMOTE CONTROL

LOADING BATTERIES

Use two size-AAA (R03) batteries.
1
Remove the battery cover at the back of
the remote control.
2
Insert batteries in the compartment,
making sure the ± and — polarities are
correctly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a thin
stick.
NOTE:
• The battery life is approximately one year in
normal use.
• When you replace the batteries, always change
both batteries, and make sure they are the same
type.
• If the remote control does not operate properly
after replacing the batteries, press the RESET
button using a thin stick.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit's signal
receiver window and press the desired button. The
unit generates a beep when it receives the signal.
• Make sure there is no curtain or other object
between the remote control and the unit.
• The remote control can send signals from up to 7
metres away.
CAUTION:
• Do not allow the signal receiver window to receive
strong direct sunlight, since it can adversely affect
its operation. If the signal receiver window is
exposed to direct sunlight, close a curtain to block
the light.
• Using a fl uorescent lamp with a quick starter in
the same room may interfere with transmission of
the signal.
• The unit can be affected by signals transmitted
from the remote control of a television, VCR or
other equipment used in the same room.
• Do not leave the remote control in direct sunlight
or near a heater. Also, protect the unit and remote
control from moisture and shock which can
discolour or damage them.
Battery cover

AUXILIARY MODE

Use this mode when the remote control is not
available.
TO TURN ON
Lift the open panel of the indoor unit and press
the AUX button.
• The red OPERATION lamp (
light and the unit will start operating in the AUTO
mode.
• The fan speed and temperature setting are set to
AUTO.
TO TURN OFF
Press the AUX button again.
• The red OPERATION lamp (
turn off.
NOTE:
• If the AUX button is pressed during normal
operation, the unit will turn off.
GB-4
) on the unit will
) on the unit will
AUX