Set Lan Ip To Framed Route; Apply Settings - Refresh - NetComm NTC-402 Configuration Manual

b Select WAN  Enable
c Set the Service Port to 22
16 Click the Save button to apply the changes you have made.

Set LAN IP to Framed Route

17 Open Basic Network >> LAN & VLAN and click the Ethernet LAN tab:
18 Set the LAN IP Address to: 10.30.4.1
19 Set the Subnet Mask to: 255.255.255.0(24)
20 Click the Save button to apply the changes you have made.

Apply Settings - Refresh

21 Open the command line and type: ipconfig /release
22 Press the Enter button.
23 Wait until the system is reconfigured.
NTC-402 – Telstra Private IP WAN Configuration Guide
CG01068 v. 1.0 October 2018
Figure 7 – Ethernet LAN configuration
Figure 8 – Command Prompt: ipconfig /release
10 of 11
© NetComm Wireless 2018