Bosch VEZ Series Installation Manual page 26

26 en | Installing a Surface Mount
1
2
3
4
8.
9.
10. Attach the Surface Mount Junction Box to the surface
F.01U.164.478 | 2.0 | 2010.02
Figure 4.6 O-ring and retaining ring for outdoor installation
M3 – .5 x 6 Phillips flat head machine screws
(supplied with AutoDome Easy II Outdoor Camera)
Retaining ring with gasket
(supplied with AutoDome Easy II Outdoor Camera)
O-ring, 3.97 mm I.D. by Ø1.78 mm
(supplied with AutoDome Easy II Outdoor Camera)
User-supplied M4 or #10 pan head screws
Determine the side of the Surface Mount Junction box in
which the external wires are to be routed and remove the
plug from the knockout.
Apply a 1/2-inch (15-mm) NPS fitting to the chosen
knockout. Ensure a water-tight fitting to maintain the IP
Environmental Protection Rating for the unit.
using four (4) user-supplied M4 or #10 pan head screws
(screws not supplied). Use a minimum screw length of
10 mm (.39 in.).
Note: For an outdoor installation ensure that the four (4)
3.97 mm I.D. by Ø1.78 mm O-rings are threaded onto the
four (4) M4 or #10 user-supplied pan head screws. Refer to
step 5.
Installation Manual
AutoDome Easy II
Bosch Security Systems, Inc.