Table Of Contents - Cisco 7941G Administration Manual

Cisco Unified IP Phone Settings
Category
IP settings
TFTP settings for
TFTP IPv4 servers
IPv6 Network Settings
DHCP settings
IP settings
TFTP settings for
TFTP IPv6 servers
(SCCP phones only)
Related Topics
Display Settings Menu, on page 2
Unlock and Lock Options, on page 2
Value Input Guidelines, on page 3
Network Configuration Menu, on page 6
Description
If you do not use DHCP in your
network, you can make IP settings
manually.
If you do not use DHCP to direct the
phone to a TFTP server, you must
manually assign a TFTP server. You
can also assign an alternative TFTP
server to use instead of the one
assigned by DHCP.
Dynamic Host Configuration
Protocol (DHCP) automatically
assigns IP address to devices when
you connect them to the network.
Cisco Unified IP Phones enable
DHCP by default.
If you do not use DHCP in your
network, you can make IP settings
manually.
If you do not use DHCP to direct the
phone to a TFTP server, you must
manually assign a TFTP server. You
can also assign an alternative TFTP
server to use instead of the one
assigned by DHCP.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Phone Setup Options
Network Configuration Menu Option
Domain Name
IP Address
Subnet Mask
Default Router 1-5
DNS Server 1-5
Alternate TFTP
TFTP Server 1
TFTP Server 2
DHCPv6
DHCPv6 Address Released
Domain Name
IPv6 Address
IPv6 Prefix Length
IPv6 DNS Server 1-2
IPv6 Alternate TFTP
IPv6 TFTP Server 1
IPv6 TFTP Server 2
Communications Manager 9.0 (SCCP and SIP)
5