Handset Setup; Handset Hardware Installation; Handset Package Contents - Cisco IP DECT 6800Series User Manual

Handset Setup

•
•
•
•
•

Handset Hardware Installation

Handset Package Contents

Your handset package has the following contents:
• Handset with attached belt clip. Inside the handset is the battery, with a piece of plastic over the battery
• Charging cradle with attached USB cable.
• Regional power adapter for the charging cradle.
• Plastic cover to replace the belt clip on the handset.
• Printed compliance document.
You need the label on the box during handset registration.
Handset Hardware Installation, on page 21
Handset Battery Charging, on page 27
Automatic Handset Configuration, on page 28
Manual Handset Configuration, on page 30
Handset Firmware Upgrades, on page 30
contacts.
Note You need to remove the plastic over the battery contacts. For more information,
see Install the Battery in the Handset, on page
Note Make sure that you save this small plastic cover, in case you want to use the
handset without the belt clip.
2
C H A P T E R
22.
Cisco IP DECT 6800 Series User Guide
21