Cisco 7941G Administration Manual page 39

Cisco Unified IP Phone Settings
Option
Recording Tone
Remote Volume
Recording Tone
Duration
Wideband Handset
Description
Indicates the loudness setting for the
recording tone that the remote party
receives. The remote party is the party
who is on a call with the party whose
phone has the recording tone option
enabled.
Range: 0 percent to 100 percent. (0
percent is –66 dBM and 100 percent is
–3 dBM.)
Default: 84 percent (–10dBM)
See Recording Tone in this table.
Indicates the length of time in
milliseconds for which the recording
tone plays.
If the value you configure here is less
than one third the interval, then this
value overrides the default provided by
the Network Locale.
Range: 0 to 3000
For some Network Locales
Note
that use a complex cadence,
this setting applies only to the
first beep tone.
See Recording Tone in this table.
Indicates whether wideband is enabled
or disabled for the handset.
Default: "Use Phone Default" on Cisco
Unified Communications Manager
Administration. (This default means
that the phone will be enabled for a
wideband handset only if the phone was
shipped with a wideband handset.)
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Media Configuration Menu
To Change
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
From Cisco Unified Communications
Manager Administration, choose Device
> Phone > Phone Configuration.
• If Wideband Handset UI Control is
enabled, you or the user can choose
> User Preferences > Audio
Preferences > Wideband Handset.
• If Wideband Handset UI Control is
disabled, use Cisco Unified
Communications Manager
Administration and choose Device >
Phone > Phone Configuration to
set this value.
If you allow this option to be user
Note
controllable (in the Wideband
Handset UI Control option), the
user-configured value takes
precedence.
Communications Manager 9.0 (SCCP and SIP)
39