Layer 3 Ip Networking; L3 Global Advanced Settings - D-Link DGS-3312SR Release 3.5 Manual

Layer 3 IP Networking

L3 Global Advanced Settings

IP Interface Settings
MD5 Key Settings
Route Redistribution Settings
Static/Default Route Settings
Static ARP Settings
RIP
OSPF
DHCP/BOOTP Relay
DNS Relay
VRRP
IP Multicast
L3 Global Advanced Settings
In order to use DVMRP, PIM-DM, RIP, or OSPF, the Switch must first be globally enabled for Layer 3 IP Networking. To
enable or disable these Layer 3 protocols as well as configure ARP Aging Time, access the L3 Global Advanced Settings
window by clicking Configuration > Layer 3 IP Networking > L3 Global Advanced Settings.
To enable DVMRP, PIM-DM, RIP or OSPF for the Switch, select Enabled using the pull-down menu for the global setting
and click the Apply button. You may later select Disabled for any of these to disable the protocol without changing any of
the settings that may have been configured for them.
The user may globally set the maximum amount of time, in minutes, which an Address Resolution Protocol (ARP) entry
can remain in the Switch's ARP table, without being accessed, before it is dropped from the table. The value may be set in
the range of 0-65535 minutes with a default setting of 20 minutes.
DGS-3312SR Stackable Gigabit Layer 3 Switch
Figure 5- 1. L3 Global Advanced Settings window
NOTE: PIM, RIP, OSPF, and DVMRP may also be globally enabled or disabled
using a separate global settings window for each protocol. The links for the
individual global settings windows are located in their respective subfolders.
Section 5
112