Multicast Forwarding - D-Link DGS-3312SR Release 3.5 Manual

Multicast Forwarding

The following figure and table describe how to set up Multicast forwarding on the Switch. Open the Forwarding &
Filtering folder and click on the Multicast Forwarding link to see the entry window below:
The Static Multicast Forwarding Settings window displays all of the entries made into the Switch's static multicast
forwarding table. Click the Add button to open the Setup Static Multicast Forwarding Table window, as shown below.
The following parameters can be set:
Parameter
Unit
VID
Multicast MAC
Address
Port Settings
Click Apply to implement changes made.
DGS-3312SR Stackable Gigabit Layer 3 Switch
Figure 4- 46. Static Multicast Forwarding Settings window
Figure 4- 47. Setup Static Multicast Forwarding Table window
Description
Select the Switch in the Switch stack to configure. 15 represents the Switch in
standalone mode.
The VLAN ID of the VLAN to which the MAC address below belongs.
The MAC address of the static source of multicast packets. This must be a multicast
MAC address.
Allows the selection of ports that will be members of the static multicast group and
ports that are either forbidden from joining dynamically, or that can join the multicast
group dynamically, using GMRP. The options are None and Egress. None means
there are no restrictions on the port dynamically joining the multicast group. If None is
chosen, then an end station attached to the port can join the multicast group using
GMRP. Egress means the port is a static member of the multicast group.
80