D-Link DGS-3312SR Release 3.5 Manual page 123

Replace DSCP (0-
63)
VLAN Name
Source IP
Destination IP
Dscp (0-63)
Protocol
Configure the Access Rule Configuration settings for the Packet Content Mask on the window below.
Figure 4- 79. Access Rule Configuration (Package Content Mask) window
The following parameters can be set:
Parameter
Profile ID
Mode
DGS-3312SR Stackable Gigabit Layer 3 Switch
Select this option to instruct the Switch to replace the DSCP value (in a packet that
meets the selected criteria) with the value entered in the adjacent field.
Allows the entry of a name for a previously configured VLAN.
Source IP Address - Enter an IP Address mask for the source IP address.
Destination IP Address- Enter an IP Address mask for the destination IP address.
This field allows the user to enter a DSCP value in the space provided, which will
instruct the Switch to examine the DiffServ Code part of each packet header and use
this as the, or part of the criterion for forwarding. The user may choose a value
between 0 and 63.
This field allows the user to modify the protocol ID used in configuring the Access
Rule Table window; depending on which protocol the user has chosen in the Access
Profile Table window.
Description
This is the identifier number for this profile set.
Select Permit to specify that the packets that match the access profile are forwarded
by the Switch, according to any additional rule added (see below).
Select Deny to specify that packets that do not match the access profile are not
forwarded by the Switch and will be filtered.
110