D-Link DGS-3312SR Release 3.5 Manual page 128

Enter the desired IP interface settings and click the Apply button. A message should appear informing you if the settings
have been successfully applied. For convenience, you may want to use the same name for the IP interface and the VLAN.
To return to the first IP Interface Settings window, click the
below follows the example IP interface setup discussed on the previous window.
Choose a name for the interface to add and enter it in the Interface Name field (if you are editing an IP Interface, the
Interface Name will already be in the top field as seen in the window above). Enter the interface's IP address and subnet
mask in the corresponding fields. Pull the State pull-down menu to Enabled and click Apply to enter to make the IP
interface effective. Use Save Changes in the Maintenance folder to enter the changes into NV-RAM.
The following fields can be set:
Parameter
Interface Name
IP Address
Subnet Mask
VLAN Name
Secondary
State
Link Status
Member Port
DGS-3312SR Stackable Gigabit Layer 3 Switch
Figure 5- 4. Example IP Interface Settings window
Description
This field displays the name for the IP interface. The default IP interface is named
"System".
Enter an IP address to be assigned to this IP interface.
Enter a subnet mask to be applied to this IP interface.
Enter the VLAN Name for the VLAN to which the IP interface belongs. The VLAN
name must match the existing VLAN name previously configured.
Use the pull-down menu to set the IP interface as True or False. True will set the
interface as secondary and False will denote the interface as the primary interface of
the VLAN entered above. Secondary interfaces can only be configured if a primary
interface is first configured.
Select Enabled or Disabled to activate or deactivate the interface.
This read only field states the current status of the IP Interface on the Switch. Link Up
denotes that the IP interface is up and running on the Switch. Link Down will denote
that the IP interface is not currently set and/or enabled on the Switch.
Specifies which ports on the Switch are a member of this VLAN.
Show ALL IP Interface Entries
115
link. The example pictured