D-Link DGS-3312SR Release 3.5 Manual page 137

Parameter
Interface Name
IP Address
TX Mode
RX Mode
Authentication
Password
State
Interface Metric
Click Apply to implement changes made.
DGS-3312SR Stackable Gigabit Layer 3 Switch
Description
The name of the IP interface on which RIP is to be setup. This interface must be
previously configured on the Switch.
The IP address corresponding to the Interface Name showing in the field above.
Toggle among Disabled, V1 Only, V1 Compatible, and V2 Only. This entry specifies
which version of the RIP protocol will be used to transmit RIP packets. Disabled
prevents the transmission of RIP packets.
Toggle among Disabled, V1 Only, V2 Only, and V1 or V2. This entry specifies which
version of the RIP protocol will be used to interpret received RIP packets. Disabled
prevents the reception of RIP packets.
Toggle between Disabled and Enabled to specify that routers on the network should
us the Password above to authenticate router table exchanges.
A password to be used to authenticate communication between routers on the
network.
Toggle between Disabled and Enabled to disable or enable this RIP interface on the
Switch.
A read only field that denotes the Metric value of the current IP Interface setting.
124