Setup Procedure - NEC N8400-086F User Manual

Supported Options by NEC EXPRESSBUILDER
The NEC EXPRESSBUILDER DVD attached to your system supports the following options for
installation.
NOTE:
disk ("OEM-FD for Mass storage device"), except ones listed below,
see "Installing with the OEM-FD for Mass storage device" and
"Installing Optional Mass Storage Driver" of "Parameter File Creator"
in Chapter 6.
Options supporting installation of OS with Express Setup
– N8403-018 Fibre Channel Controller
– Storage and I/O Blade AD106a
Other options
– N8403-018 Fibre Channel Controller
– Storage and I/O Blade AD106a
NOTES:
The driver of option card mentioned above is stored in the NEC
EXPRESSBUILDER DVD.
If you use the board not mentioned above, the Express Setup will fail.
Refer to the instructions attached to the board.

Setup Procedure

The following describes the procedure of installing Windows Server 2003 x64 Editions/Windows
Server 2003 with local installation.
IMPORTANT:
described earlier in this chapter. The partition creation and the
installation to dynamic disks are described.
If you want to install the other boards by using a driver floppy
Before starting the setup, always see the notes
Installing the Operating System B-7