NEC N8400-086F User Manual page 128

5-56 Installing the Operating System with Express Setup
Installation of Mass storage device not to be supported by Express Setup
If you would like to install or re-install the OS when the system has new mass storage device not to
be supported by NEC EXPRESSBUILDER, you have to set as follows.
1.
Read the manual supplied with the mass storage device before setting the server.
2.
If the mass storage device is RAID Controller, configure the RAID System before running
the NEC EXPRESSBUILDER.
3.
Boot the system from NEC EXPRESSBUILDER DVD.
4.
Select [Load the optional driver into the EXPRESSBUILDER] from the Top menu, click
[Next].
Setting the driver disk for the mass storage controller. Press the "Perform" button.
NOTE: By choosing this option, you can load the driver provided by
CD-ROM or floppy disk to proceed with the Express Setup.
5.
Perform Express Setup with the following settings.
(a) When "Enter RAID settings" appears, check "Skip the logical drive creation".
(b) Select "Apply OEM-Disk for Mass storage device".
6.
Copy the driver for the mass storage device in the Express Setup.
Insert the floppy disk attached the mass storage device into the floppy disk drive.
Continue the Express Setup, referring to messages displayed on the display.