Section 3 Cabling Requirements And Specifications - NEC UNIVERGE SV8100 Configuration Manual

UNIVERGE SV8100
The CD-CP00 provides:
C
S 3
ABLING
ECTION
This section provides cabling requirements and specifications for various equipment
used in the SV8100 system.
Only the DT300/DT700, D
telephones, cordless telephones and wireless telephones discussed in the document
can be installed on the SV8100 system.
Configuration Guide
200 trunk ports maximum
512 extension ports maximum
512 ports digital/IP extensions maximum
256 analog ports maximum
256 virtual extensions
Connection for 32/64/128 VoIP Daughter Board (PZ-32IPLA/PZ-64IPLA/
PZ-128IPLA)
Connection for Voice Mail Daughter Board (PZ-VM21)
Connection for Expanded Memory (PZ-ME50)
Supports TAPI 1.x
1 Green Status LED
4 Red Status LEDs
5 diagnostic LEDs which indicate the status of various system functions
During normal operation, the "RUN" LED will be flashing and the remaining
LEDs will be off.
700x700 Time Division Multiplex Switch (TDM Switch)
Digital Phase Locked Loop (DPLL)
R
EQUIREMENTS AND
term
To avoid damage to equipment, do not install the
term
D
DTP) terminal uses -24V and has no protection from
the -48V power supply used by the SV8100 system.
S
PECIFICATIONS
Series i telephones, Aspire Model C, single line
70 on the SV8100 system. The D
Issue 2.00
term
70 (DTU/
5 - 7