If Your Network Does Not Support Dhcp; Configuring Parameters - Nortel IP Phone 2002 User Manual

Standard
Table 16 DHCP configuration parameters
Parameter
Voice VLAN
PCUntagAll
After you press the Ok soft key for the last configuration parameter, the
system displays the message "Locating Server".

If your network does not support DHCP

Use the following procedure if your network does not support DHCP.

Configuring parameters

1 At the prompt in the display area of your phone, enter 0 by using the dialpad,
to indicate that DHCP is not supported.
2
At the prompt in the display area of your phone, enter the configuration
parameters listed in
Table 17 Configuration parameters
Parameter
SET IP
NETMSK
DEF GW
Value
0-No, 1-Yes
0-No, 1-Yes
Table 17 "Configuration parameters" on page
Warning: The VLAN parameter must not be selected unless the
underlying network switches are configured to filter on VLAN IDs.
Otherwise, the IP Phone 2002 can fail to work properly.
Value
<valid IP address>
<valid subnet mask>
<valid Default Gateway>
Definition
Default 0 (for No)
Note: You are not prompted
for Voice VLAN if 802.1Q is
not enabled.
Default 0 (for No)
109.
Definition
IP address of your
IP Phone 2002 provided by
your system administrator
Subnet Mask provided by
your system administrator
Default gateway IP network
address provided by your
system administrator
IP Phone 2002 User Guide
109