Standard
106
Begin the initialization process
To begin the initialization process, at the flashing Nortel Networks screen, quickly
press each of the four soft keys (located at the bottom of the display screen) once,
pressing from left to right.
If your network supports DHCP go to
page
106. If your network does not support DHCP go to
support DHCP" on page
If your network supports DHCP
At the prompt in the display area of your phone, enter the configuration
parameters listed in
Table 16 DHCP configuration parameters
Parameter
DHCP (enable)
DHCP (full or partial)
Cached IP?
NN42020-126 MCS 5100 Release 4.0
Tip: If you miss the flashing introduction screen, unplug and plug in
your IP Phone 2002 to reach the configuration screen where you can
press the soft keys.
109.
Table 16 "DHCP configuration parameters" on page
Tip: Your system administrator can tell you whether your network
supports DHCP.
Warning: The VLAN parameter must not be selected unless the
underlying network switches are configured to filter on VLAN IDs.
Otherwise, the IP Phone 2002 can fail to work properly.
Value
1
1
0-No, 1-Yes
Standard 01.05
"If your network supports DHCP" on
"If your network does not
Definition
Yes
Partial
Select Yes if the cached IP
address for this telephone is
to be used if the DHCP
server fails.
106.
March 2009