Table of Contents
Advertisement
1M28 and 1M75 User's Manual
Figure 18: Triggered Mode with External Edge Triggered Exposure Control
EXSYNC
INTEGRATION
2.10 Dummy Test Row
For testing the readout chain a row of test pixels has been implemented on the sensor
chip. The pixels in this row are fixed to a pattern of black and white pixels. This row can
be read out in place of row 1023, at the beginning of the frame. Note: The camera powers
up with the dummy test row turned off. For information on turning the dummy test row
on , refer to Table 14 on page 37.
2.11 LED Status
A status LED on the backside of the camera provides the following information about the
state of the camera:
•
•
•
•
•
DALSA
PRELIMINARY
PCLK
PRIN
FVAL
LVAL
DATA
In normal operation mode, the LED shows a green light while valid data is read out.
At slow frame rates the LED blinks with the FVAL signal.
At high frame rates the LED changes to an apparently continuous green light, with
intensity proportional to the ratio of readout time over frame time. In some
circumstances, (for example, a relatively long frame time and a very small ROI
setting) the pulse of the LED might be too short to be visible in daylight conditions,
even if the camera is working properly.
If the data read out from the sensor is not within the ADC conversion range (over or
under exposed), the LED changes to red while the saturated data is read out.
The status LED changes to red while the serial communication is active.
EXSYNC is ignored in mode constant image data rate
CPRE
Line Pause
First Line
Line Pause
Last Line
Line Pause
03-32-00525-03
27
Advertisement
Table of Contents
