Table of Contents
Advertisement
1M28 and 1M75 User's Manual
Saving and Loading EEPROM Settings
IMPORTANT: If you are using PFRemote for the first time, you should dump the EEPROM in order
!
to save the current factory settings. This will enable you to recover the factory settings if they are
accidentally overwritten.
To save the factory settings:
1.
2.
To recover EEPROM settings:
1.
2.
3.
Configuring the Camera with PFRemote
To configure the camera:
1.
2.
DALSA
PRELIMINARY
If the camera is properly connected, the camera you are using is displayed:
Figure 20: Camera Name is displayed after a Successful Connection
If the camera is not connected properly, you will receive an error message. Consult
the troubleshooting section in the PFRemote Help for possible solutions.
Select Tools → Dump EEPROM.
Locate where you want to save the HEX file, enter a file name, and click Save.
Select Tools → EEPROM Recovery.
Locate the HEX file to upload and select Open.
After the camera has completed uploading the file, shut down and then restart your
camera.
In PFRemote, open a connection with the camera. For details on opening a connection
with your camera, see Opening PFRemote on page 30.
Right click on the camera name and select Configure.
31
03-32-00525-03
Advertisement
Table of Contents
