Datalogic Magellan 3200VSi Instructions

Follow these instructions to upload a 2D license file to either a Magellan 3200VSi or 3300HSi model scanner. This will upgrade
the scanner to read 2D bar codes in addition to the already available symbologies. Read all of these instructions before starting.
1. If you have not already done so, remove the scanner from its installed position to allow access to the microSD card slot.
For the 3300HSi scanner, use a coin or similar blunt
object to lever the top cover from the scanner, then grasp
the lift handles and carefully lift the unit from the counter.
Coin Slot
2. Ensure there are no other cables attached to the scanner, then apply power and wait for the reset beep.
3. Lift and rotate the rubber cover to access the card slot (see the illustration on the next page), then carefully insert the 2D
upgrade microSD card into the slot until it "clicks" into place. If installed properly, you should immediately hear a rapid
sequence of tones to indicate the upgrade process has started.
The microSD card slot is spring loaded. Keep your finger lightly in place atop the card until you are
sure it is fully seated in place.
Use your finger or thumbnail to push in on the top edge of the card to be slightly below flush with
the scanner enclosure when inserting or removing the card. This will engage/disengage the
CAUTION
spring mechanism.
Never insert tools or other foreign objects into the microSD card slot.
Improper insertion of the microSD card can result in the premature exhaustion of 2D upgrade
licenses.
If you do not hear audible tones upon microSD card full insertion, the card does not contain any
2D upgrade licenses.
© 2011 Datalogic Scanning, Inc.
Top Cover
Lift Handles
820043714 (Rev. B)
2D Upgrade Kit
TM
Magellan 3200VSi / 3300HSi
For the 3200VSi model, separate the scanner from
its back cover.
Back Cover
Optional Back
Cover/Stand
Assembly
November / 2011