Removing The Controller Card Cage - IBM F10 Service Manual

Figure 41. DC Battery and Power Harness Connections
9. Lift the controller card cage assembly out of the chassis (Figure 42).
Grasp and lift the top, front edge of the controller card cage slightly (about one
inch). Pull the card cage firmly toward the front until the connectors on the
controller backpanel exit the holes in the connector plate. Lift the controller
card cage out of the chassis and set it aside.
Figure 42. Removing the Controller Card Cage
10. What do you want to do next?
v Reassemble the controller module. Go to the next step.
v Service the controller backpanel. Return to "Replacing a Failed Controller
Backpanel" on page 98.
85
Chapter 3. Getting Started