Removing And Installing A Power Supply Fan Fru - IBM F10 Service Manual

Figure 55. Removing and Installing a Power Supply Fan FRU
4.
5. Check the LEDs (Figure 33 on page 78).
6. Replace the back cover.
End of Procedure
110
IBM 2102 Model F10 and Model D00 Service Guide
Install the new power supply fan FRU (Figure 55).
The lever will snap down when the FRU is seated properly in the chassis. If the
lever remains up, push on the power supply fan FRU until it snaps into place.
The green power LED should be on and the amber fault LEDs should be off. If
the power LED remains off or the fault LED turns on, make sure that the power
supply fan FRU is inserted all the way into the chassis and locked in place.
If this does not correct the problem (the fault LED remains on), it may indicate
that the new fan FRU is malfunctioning. Replace the power supply fan FRU with
another FRU. If a spare power supply fan FRU is not available, turn off the
controller module. This will prevent the power supplies from overheating while
you get a replacement fan.