Removing The Sas Riser-Card And Controller Assembly - IBM x3650 - System M2 - 7947 User Manual

If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 106.

Removing the SAS riser-card and controller assembly

To remove the SAS riser-card and controller assembly from the server, complete
the steps for the applicable server model.
v 12-drive-capable server model:
1. Press the assembly release latch toward the rear of the server and lift that
end of the SAS controller assembly a little. Place your fingers underneath the
upper portion of the SAS riser card and lift the assembly from the system
board.
2. Lift the assembly out of the server.
Chapter 2. Installing optional devices
91