Removing The Sas Riser-Card And Controller Assembly - IBM System x3650 M2 Installation And User Manual

Removing the SAS riser-card and controller assembly

Downloaded from www.Manualslib.com
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 106.
To remove the SAS riser-card and controller assembly from the server, complete
the steps for the applicable server model.
v 12-drive-capable server model:
1. Press the assembly release latch toward the rear of the server and lift that
end of the SAS controller assembly a little. Place your fingers underneath the
upper portion of the SAS riser card and lift the assembly from the system
board.
2. Lift the assembly out of the server.
manuals search engine
Chapter 2. Installing optional devices
91