Emergency Transmission - Icom IC-F9010 SERIES Operating Manual

2
ANALOG MODE OPERATION
n Emergency transmission
When [Emergency] is pushed and held for the specified time
period , the DTMF emergency signal is transmitted once, or
* 1
repeatedly , on the specified emergency channel.
* 1
A repeat emergency signal is automatically transmitted until
turning the transceiver OFF, or pushing [Home]
When no emergency channel is specified, the signal is trans-
mitted on the previously selected channel.
If you want to cancel the emergency call, push and hold
[Emergency] again before transmitting the call.
If your transceiver is programmed for Silent operation, you
can transmit Emergency calls without the beep sounding or
the LCD display lighting.
IMPORTANT: It is recommended to set an emergency
channel individually to provide the certain emergency call
operation.
13 13
D NOTES
Depending on the pre-setting, the following functions are au-
tomatically activated. Ask your dealer for details.
• Auto TX function
.
* 2 The transceiver automatically transmits the microphone audio
for the specified time period
mission.
- The HM-148G or HM-152
transceivers.
• Auto RX function
The transceiver stands by in the audible mode for the speci-
fied time period
* 1 Depending on the pre-setting. Ask your dealer for details.
* 2 For only transceivers whose revision number is 1.7 or later.
after the emergency call trans-
1
*
is required for Mobile
hand microphone
, after the emergency call transmission.
* 1