Icom IC-F9010 SERIES Operating Manual page 12

1
PREPARATION
D APCO P25 modes operation (Continued)
SITE SELECT KEY "SSEL" (Trunking mode only) (p. 29)
Push to select "SITE 1," then push again to display the site
information (RFSS ID and SITE ID), and you can edit the
RFSS and SITE IDs. Push and hold [Site Select] for 1 sec.
to set and return to normal operation.
INDIVIDUAL KEY "INDV" (p. 29)
Push to directly enter the Individual ID selection mode,
then select a desired Individual ID code using [CH Up]/[CH
Down] or [CH Up/Down].
• The Individual ID can be edited with the 10-keypad*. (Depending
on the pre-setting.)
*10-key types only.
• While in the Individual ID selection mode, push to cancel and
return to normal operation.
TALKGROUP KEY "TGID" (p. 31)
Push to directly enter the Talkgroup ID selection mode,
then select a desired Talkgroup ID code using [CH Up]/[CH
Down] or [CH Up/Down].
• While in the Talkgroup ID selection mode, push to cancel and
return to normal operation.
REKEY "REKY" (OTAR mode only) (p. 57)
Push and hold for 1 sec. to transmit a Key Management
Message (KMM-Hello command) to a Key Management
Facility (KMF) to request rekeying.
9
KEYSET "KSET" (OTAR mode only) (p. 57)
➥ Push to enter the keyset selection mode, then select a
desired keyset using [CH Up]/[CH Down] or [CH Up/
Down].
➥ During the keyset selection mode, push and hold this key
for 1 sec. to set the selected keyset, and push again to exit
the keyset selection mode.