Seventh Stage (Disassembly Of Differential Gear) - Cub Cadet 8354 Service Manual

8.7 SEVENTH STAGE (DISASSEMBLY OF
DIFFERENTIAL GEAR)
1. Using bearing puller, pull out spiral bevel gear (2)
and bearing (1) simultaneously.
2. Loosen bolt (3) and disconnect differential case
cover (4).
3. Pull out parallel pin (11) and then disconnect differ-
ential pinion shaft (8).
4. Disconnect differential pinion (7), differential side
gear (6), differential pinion washer (10), and shim
(9) from case (5).
• Mark disassembled part with its origi-
nal position in order to assemble
again into original position.
CAUTION
(When reassembling)
• Assemble each part into the original position
marked prior to disassembly.
• Apply differential gear operating part with molybde-
num (Three bond 1901 or equivalent).
Sect. Spec.
Differential case M10
cover tightening bolt
D615-W02 May-2003
K&T Saw Shop 606-678-9623 or 606-561-4983
www.mymowerparts.com
Tightening torque
48.0 ~ 55.9 N·m
4.9 ~ 5.7 kgf·m
35.4 ~ 41.2 lbf·ft
(10) Differential Pinion Washer
(11) Parallel Pin
(1) Ball Bearing
(2) Spiral Bevel Gear
(3) Bolt
(4) Differential Case Cover
(5) Front Differential Case
(6) Differential Side Gear
(7) Differential Pinion
(8) Differential Pinion Shaft
(9) Shim
FRONT AXLE
615W726A
7-17